The Boss OC-2 is the brown compact analogue octave pedal Boss brought out in 1982. It adds a note one octave below what you play and another two octaves below, and you mix both with your dry signal. It's monophonic. It's a bit temperamental. And over four decades it has become one of the standard sub-octave sounds on bass.
I'll go through how it tracks, what the knobs do, how to make it behave, and why it gets on so well with fuzz, as it did on Chris Wolstenholme's board in Muse.
What is the Boss OC-2?
One of Boss's compact pedals. Collector sources say the first version from 1982 was called the "Octaver", and that it was renamed "Octave" around 1984, when production moved from Japan to Taiwan. Sources disagree on when it was discontinued (2002 and 2003 both get cited). Boss followed it with the OC-3, which added a polyphonic mode, a drive mode and a bass input. Then in 2020 came the OC-5, with a Vintage mode that Boss says is based on the OC-2's monophonic sound.
Think about that for a second. Boss built an OC-2 mode into a new pedal nearly forty years on, because players still wanted the old one. The good news from a production run of around twenty years is that a used OC-2, unlike a lot of sought-after pedals, isn't hard to find.
The controls
Three knobs. None of them is a tone control.
OCT 1 sets the level of the note one octave below the one you play. OCT 2 does the same for the note two octaves down. DIRECT LEVEL is your own dry signal, mixed in with the octaves.
Since each voice gets its own level, you can mix them however you like. Just OCT 1 gives you a fat, synth-ish line. Both octaves under a quiet direct signal is a sub rumble. Or tuck a little of each under a full direct signal to thicken a part without it obviously sounding like an effect, which is how I use it most of the time.
How the OC-2 tracks
It's analogue and monophonic, so it follows one note at a time and builds the lower octaves from that. Give it a clean single note and the sub is solid, round and synth-like. Give it something confusing, like a chord, a note heavy with harmonics or a note that's dying away, and it wobbles, warbles or just lets go.
That wobble is part of the sound, though. Most people who love the OC-2 love it precisely because it isn't perfect. It follows how hard you play, it reacts to your technique, and it drops off at the end of a decaying note in a way digital octavers tend to smooth over.
One catch. The OC-2 distorts if you feed it a hot signal, and active basses are the usual culprit. Some players like the grit. If you don't, turn the bass down or pad the signal before the pedal.
Getting it to track
The neck pickup is your friend here. It has a stronger fundamental and fewer harsh overtones, so the pedal gets a clear note to follow. Roll the tone back as well, since less treble means fewer harmonics to confuse it.
Then it comes down to playing:
- Single notes only. The OC-2 doesn't do chords. Double stops, or open strings ringing under a fretted note, will make it stutter.
- Mute cleanly. Leftover ringing from the last note gets picked up just like a chord would. Tidy left-hand muting makes a big difference.
- Stay in the low to middle of the neck. That's where a bass spends most of its time anyway, and it's where the OC-2 is happiest. Two octaves below a high note is a strange place regardless.
And put it early in the chain, before anything that adds harmonics or squashes your dynamics, so it hears your playing as directly as possible. If I see an OC-2 after a compressor on someone's board, that's the first thing I move.
Why the Boss OC-2 is a bass classic
It sounds like it was made for bass. You get a tight, round sub that sits under the part and can take over the bottom octave of a mix without turning to mud, especially with OCT 2 kept low. It takes seconds to set. And its tracking quirks reward careful playing, which I'd count as a feature.
It's turned up on a lot of rigs over the years. Muse's is one of the better documented.
The octave in Muse's bass rig
In a 2010 Dunlop TV interview filmed backstage at the Oakland Arena, Shane Goodwin, then Muse's bass tech, walked through Chris Wolstenholme's pedalboard. After the Animato and the Big Muffs, he summed them up:
Well, there's actually a big muff on each rig. But, um, yeah, those two combined are basically sound with a big splash of octave.
The camera zooms in on a Boss OC-2 as he says it.
It wasn't the only octave in Chris's setup, mind. An Electro-Harmonix Octave Multiplexer is on the board in the same video, and the equipment list printed with his 2009 interview with Bryan Beller, around The Resistance, puts it in the effects loop that fed all three of his amps, with the Human Gear Animatos in the loops for amps 2 and 3. Chris mentions octavers in passing in that interview too: "apart from things like delays and otavers" (as the transcription spells it), they kept distortion off amp 1 so it stayed clean and held the bottom end.
So both octave pedals show up in the documentation from that period. The job they're doing doesn't change, though. Fuzz for teeth, a clean amp underneath, and plenty of octave below the lot. Our Muse bass rig page maps the whole three-amp system, and the Human Gear Animato post covers the fuzz side.
Octave and fuzz together
It's one of the great bass combinations. Order matters a lot, though.
Octave first
Start here. The OC-2 gets your clean signal and tracks it properly, then the fuzz chews up the original note and both octaves together into one big, thick sound. The sub gives the fuzz something solid to bite on, and the result can get very close to a synth.
Fuzz first
Now the OC-2 has to track a signal stuffed with harmonics and sustain. It'll glitch, jump octaves and sputter. Sometimes that chaos is exactly what a part needs. I wouldn't build an everyday sound on it.
Parallel paths
Chris's rig split the signal across separate amps rather than running everything in one line. You can copy that in a DAW: one track with octave into a clean preamp, another with fuzz, and balance them on the faders. The sub stays clean and solid and the fuzz adds the edge on top.
Starting settings
These are starting points, not anyone's published settings.
- Thick synth bass: OCT 1 around 2 o'clock, OCT 2 off, DIRECT LEVEL around noon. Into a fuzz, with a clean signal blended underneath.
- Sub weight under a full mix: OCT 1 low, OCT 2 around 10 o'clock, DIRECT LEVEL high. Check on small speakers so you don't overdo the sub.
- Pure sub line: DIRECT LEVEL off, OCT 1 up, a little OCT 2. Neck pickup, tone rolled back, clean playing.
The plugin route: Octaver GO-2
We make Octaver GO-2, a plugin recreation of the Boss OC-2. We built it with a physical OC-2 on the bench and compared the two note by note across the neck and across every setting of the three knobs, until we couldn't tell the plugin from the pedal. It isn't the pedal. But it tracks, and stumbles, the way the hardware does.
It has OCT 1, OCT 2 and DIRECT LEVEL, plus one extra. In ORIGINAL it distorts on hot signals the way the pedal does. Switch to CLEAN and hot signals pass without the distortion, with nothing else about the sound changing. Handy if you play an active bass and want the OC-2's sub minus the grit.
Same tracking advice applies: neck pickup, tone rolled back, single notes. It runs on Windows and Mac as VST3, CLAP and Audio Unit, and there's a free trial. The trial is the full plugin, but without a licence key it goes silent for 5 seconds out of every 40.
Getting the sound
The OC-2 is a simple, slightly unpredictable analogue octave, and for my money it suits bass better than almost anything that came after it. Feed it clean single notes, put it before your fuzz, keep a clean low end in the mix, and it'll do what it's been doing on records for decades. If you'd rather try it in your DAW first, grab the Octaver GO-2 trial and stick it on a DI track.
Gromtech Effects is not affiliated with, sponsored by or endorsed by Boss, Roland, Muse, Chris Wolstenholme, Shane Goodwin, Dunlop, Electro-Harmonix or Human Gear. Names are used only to describe the music and the hardware.
Sources
- Dunlop TV interview with Shane Goodwin (2010), written up by Effects Bay
- Chris Wolstenholme interviewed by Bryan Beller (2009), republished by Guitar World
- Gear Icons: Boss Octave pedals, Mixdown
- OC-2, Thermionic Studios wiki
- Boss OC-2 on MuseWiki
- Boss OC-3 product page
- Boss Unveils the OC-5 Octave Pedal, No Treble